Coating Defect Guide
Understand the surface. Narrow down the cause.
Practical information for investigating coating defects and reviewing application conditions.
Coating defects: checking the surface, film and curing conditions
A practical checklist for recording coating defects and reviewing surface preparation, film thickness and curing conditions.
↗
Orange peel: diagnosing a pebbled finish
Check atomisation and flow when the finish remains pebbled.
↗
Runs and sags on vertical surfaces
Review excessive film build and overlap on vertical parts.
↗
Craters and fisheyes: tracing contamination
Isolate contamination from the part, air supply and handling tools.
↗
Pinholes on castings and welds
Separate substrate porosity from application-related air entrapment.
↗
Solvent popping after drying or heating
Review film build and drying conditions that can trap solvent.
↗
Peeling and intercoat adhesion failure
Identify the interface where the coating has failed.
↗
Blistering during service
Review moisture exposure, surface contamination and service conditions.
↗
Dry spray and rough overspray deposits
Check conditions that deposit partially dried spray on the surface.
↗
Colour and gloss variation between coated parts
Compare batch, mixing, film build and cure conditions separately.
↗
Soft or tacky coating and incomplete cure
Check mixing records, actual part temperature and film thickness.
↗